Fablicator 3-D Printer

Upload stereolithography (STL) file via USB or SD card onto the on-board computer. Use KISSlicer software package that is loaded onto the attached computer. Save the file as G code in the computer, load this into the 3-D printer, and set the extruder and bed temperatures. 3-D printing materials are supplied by the BME Shop. Maximum print size is 8 inches by 8 inches. This machine is located in the BME Shop in the Whitaker Biomedical Engineering Building.

Image: 
Hours: 
BME Machine Shop hours are dependent upon the semester; contact instructors for open hours
Access Notes: 
Contact Marty Jacobson or Raja Schaar for training; access granted to all majors with training
Contact Information: 
Marty Jacobson (at marty@gatech.edu) or Raja Schaar (at raja@gatech.edu)
Safety and Training: 
Marty Jackson and Raja Schaar hold a training series one to two times a week at the start of every semester. Contact the instructors to be trained
GIS data: 
POINT (-84.396762 33.778493)
Address: 
313 Ferst Dr NW
Atlanta, GA 30332
United States
Map of Georgia Tech

Georgia Institute of Technology
North Avenue, Atlanta, GA 30332
Phone: 404-894-2000