Spindle Sander - Design Shop

Spindle sander is used to clean up simple curved cuts in wood.  Sanders can only effectively sand small amounts.  Cutting first at bandsaw near the layout line then cleaning up at sanders is correct.

Image: 
Cylinder Sander
Hours: 
See CoA Shop TA: anytime the CoA Shop is open
Access Notes: 
Access is given to students enrolled in College of Design classes and that require shop use. Orientation sessions for these students are given at the beginning of each semester. After attendance, students are granted access to level 2 equipment found in the Design Shop (Table saw, Band saw, Chop Saw, Sanders and Drill press) Other equipment may require additional training and will need to be scheduled in advance.
Contact Information: 
Tripp Edwards
Safety and Training: 
Eye protection and nuisance masks
GIS data: 
POINT (-84.395397 33.776145)
Address: 
247 Fourth St, NW
Atlanta, GA 30332
United States
Tags: 
Map of Georgia Tech

Georgia Institute of Technology
North Avenue, Atlanta, GA 30332
Phone: 404-894-2000